If you are not sure which one to use, then go ahead and open Chrome, Firefox, or Edge. Open up whichever internet browser that you are comfortable with. To log in you will need to use a web browser since the Technicolor CGM4140COM uses a web interface to access router configurations.
Log in to your Technicolor CGM4140COM router. Step 2 - Login To Your Technicolor Router Or follow our Static IP Address guides to setup a static IP address.Īfter setting up a static ip address on your devices you need to login to your router.
Technicolor modem cga4131 free#
Recommended - Our free program will setup a static IP address for you. In order to ensure that your ports remain open in your device even after it reboots, it is important to set up a static IP address in your device. If so, you are not alone! We are here to help walk you through the steps to open a port in the Technicolor CGM4140COM router. The process of opening ports in your router may seem like a difficult task. Find the Port Forwarding link located near the left of the screen and click on it.Click the Advanced tab, which is at the left of the screen.Find the Port Forwarding section in your Technicolor CGM4140COM router.Go ahead and log in to your Technicolor CGM4140COM router.Set up a static IP address on the computer or device that you are forwarding ports to.Forwarding these ports directs incoming data to a specific device or application.įollow the steps below to open ports in your Technicolor CGM4140COM router: You can open ports in your CGM4140COM by assigning specific ports to an IP address. The Technicolor CGM4140COM can unblock certain incoming connections through port forwarding or by opening a port. Sometimes you want to allow network access to a specific application in order to play a game, connect a device, or use an app. This is an important feature that helps you to control which applications have access to your network. Your CGM4140COM router helps to protect your network by blocking incoming internet connections.
Technicolor modem cga4131 Pc#
You can now connect to the netgear GUI on 192.168.1.1 and the Technicolor GUI on 192.168.1.254, if the technicolor is connected to the internet then the PC should have web access from whichever router it's connected to.Novem(Last Updated: September 17, 2021) | Reading Time: 5 minutes You may need to reboot both routers and PC for this to happen. In this case you don't need the PC to be on a static IP address as the Technicolor will give out IP addresses via DHCP. ensure both are switch on.Ĭonnect to the netgear to the Technicolor via any of the ethernet ports and connect the PC to either of the routers again via any of the ethernet ports Now the bit which I think is causing the confusion, after disabling DHCP you won't be able to connect to the netgear gui unless:ġ) the PC is placed on a static IP address withing the routers subnet (192.168.1.10 will do)Ģ) the netgear is connected to the Technicolor and using it's DHCP server. Once connected to the netgear router, all you need do is:ġ) change 192.168.0.1 to 192.168.1.1 - don't click apply yet.Ģ) remove the tick from "Use Router as DHCP server"ģ) Now click apply, at this stage you'll lose connection to the netgear. See the attached screen shot of a typical netgear LAN IP Setup: